Wheel Alignment Standard
WHEEL ALIGNMENT STANDARDa. FRONT WHEEL ALIGNMENT
1. Vehicle Height (Unloaded Vehicle)
NOTICE:
- Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
- Be sure to perform measurement on a level surface.
- If it is necessary to go under the vehicle for measurement, confirm that the parking brake is applied and the vehicle is secured with chocks.
Measuring points:
A: No. 1 lower suspension arm bushing set bolt ground clearance
B: Rear axle beam set bolt ground clearance
C: Front wheel center ground clearance
D: Rear wheel center ground clearance
2. Wheel Angle (Unloaded Vehicle)
If the angles are not as specified, check and adjust the right and left rack end lengths.
3. Camber (Unloaded Vehicle)
4. Caster (Unloaded Vehicle)
5. Steering Axis Inclination (Unloaded Vehicle) except TMC Made:
6. Toe-in
HINT:
- Measure B - A only when C + D cannot measured.
- If toe-in is not within the specified range, adjust at the rack ends.
b. REAR WHEEL ALIGNMENT
1. Toe-in (Unloaded Vehicle)
- Measure B - A only when C + D cannot be measured.
2. Camber (Unloaded Vehicle)
HINT: Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.