Installation

LIGHTING (EXT): STOP LIGHT SWITCH: INSTALLATION

INSTALLATION

1. INSTALL STOP LIGHT SWITCH ASSEMBLY





(a) Insert the stop light switch assembly until the rod hits the cushion.
NOTE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.





(b) Make a quarter turn clockwise to install the stop light switch assembly.
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)
NOTE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.





(c) Connect the connector.





(d) Check the protrusion of the rod.
Protrusion of the rod:
1.5 to 2.5 mm (0.059 to 0.098 in.)
If the protrusion is not within the specified range, adjust it.
NOTE: Do not depress the brake pedal.