Installation

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: INSTALLATION

INSTALLATION

1. INSTALL STEERING KNUCKLE





(a) Using SST and a press, install a new front axle hub bearing to the steering knuckle.
SST: 09950-60020
09951-00720
SST: 09950-70010
09951-07100
2. INSTALL FRONT DISC BRAKE DUST COVER Installation
3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY Installation
4. INSTALL FRONT AXLE HUB HOLE SNAP RING Installation
5. INSTALL FRONT LOWER BALL JOINT Installation
6. INSTALL FRONT AXLE ASSEMBLY Installation
7. INSTALL FRONT LOWER SUSPENSION ARM Installation
8. INSTALL TIE ROD END SUB-ASSEMBLY Installation
9. INSTALL FRONT DISC Installation
10. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Replacement
11. INSTALL FRONT AXLE HUB NUT Installation
12. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Replacement
13. REMOVE FRONT DISC Removal
14. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub
15. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub
16. INSTALL FRONT DISC Installation
17. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Replacement
18. CONNECT FRONT SPEED SENSOR (for TMC Made) Disposal
19. CONNECT FRONT SPEED SENSOR (except TMC Made) Installation
20. INSTALL FRONT AXLE HUB NUT Installation
21. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
22. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT: Service and Repair

23. CHECK FOR SPEED SENSOR SIGNAL
HINT: Test Mode Procedure