Removal

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: REMOVAL

REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.

1. REMOVE FRONT WHEEL
2. REMOVE FRONT AXLE HUB NUT (for 2AZ-FE) Removal
3. REMOVE FRONT AXLE HUB NUT (for 2ZR-FE) Removal
4. SEPARATE FRONT SPEED SENSOR (for TMC Made) Removal
5. SEPARATE FRONT SPEED SENSOR (except TMC Made) Removal
6. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Replacement
7. REMOVE FRONT DISC Removal
8. SEPARATE TIE ROD END SUB-ASSEMBLY Removal
9. SEPARATE FRONT LOWER SUSPENSION ARM Removal
10. REMOVE FRONT AXLE ASSEMBLY Removal
11. REMOVE FRONT LOWER BALL JOINT Removal
12. REMOVE FRONT AXLE HUB HOLE SNAP RING Removal
13. REMOVE FRONT AXLE HUB SUB-ASSEMBLY Removal
14. REMOVE FRONT DISC BRAKE DUST COVER Removal
15. REMOVE STEERING KNUCKLE
(a) Place the front axle hub bearing inner race (outside) on the front axle hub bearing.





(b) Using SST and a press, remove the front axle hub bearing from the steering knuckle.
SST: 09527-17011
SST: 09950-60010
09951-00640
SST: 09950-70010
09951-07100