Installation

DOOR LOCK: UNLOCK WARNING SWITCH: INSTALLATION

INSTALLATION

1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY





(a) Attach the 2 claws to install the unlock warning switch onto the steering column upper bracket.
HINT: Slide the unlock warning switch in the direction shown by the arrow in the illustration to install it.

2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY Reassembly
3. INSTALL SOLENOID WIRE (for Automatic Transaxle) Reassembly
4. INSTALL KEY INTERLOCK SOLENOID (for Automatic Transaxle) Reassembly
5. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Manual Transaxle) Reassembly
6. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Automatic Transaxle) Reassembly
7. INSPECT STEERING LOCK OPERATION Testing and Inspection
8. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY Reassembly
9. INSTALL STEERING POST ASSEMBLY Installation
10. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD
11. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 2WD) Installation
12. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 4WD) Installation
13. INSTALL STOP LIGHT SWITCH ASSEMBLY Installation
14. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY Installation
15. INSTALL INSTRUMENT PANEL SUB REINFORCEMENT Installation
16. INSTALL COLUMN HOLE COVER SILENCER SHEET Installation
17. INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) Installation
18. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY Installation
19. INSTALL UPPER STEERING COLUMN COVER Installation
20. REMOVE LOWER STEERING COLUMN COVER Installation
21. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation
22. INSTALL NO. 1 SWITCH HOLE BASE Installation
23. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL Installation
24. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Automatic Transaxle) Installation
25. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation
26. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation
27. INSTALL FRONT CONSOLE BOX ASSEMBLY
HINT: Refer to the instructions for Installation of the front console box Installation.

28. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
HINT: Refer to the instructions for Installation of the upper instrument panel Installation.

29. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD
30. ADJUST SPIRAL CABLE Installation
31. INSTALL STEERING WHEEL ASSEMBLY Installation
32. INSTALL STEERING PAD Installation
33. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation
34. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation
35. INSPECT STEERING WHEEL CENTER POINT
36. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
37. INSPECT STEERING PAD Installation
38. CALIBRATE TORQUE SENSOR ZERO POINT
HINT: Programming and Relearning.

39. INSPECT SRS WARNING LIGHT
HINT: Diagnosis System.