Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: INSTALLATION

INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.
- If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.

1. INSTALL FRONT SPEED SENSOR

(a) Install the front speed sensor with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)

NOTICE:
- Prevent foreign matter from attaching to the sensor tip.
- Do not file the hole or the contact surface because the gap between the magnet rotor and front speed sensor is important.

(b) Install the clamp to the shock absorber.

(d) Install the brake flexible hose with the bolt.
Torque: 29 Nm (296 kgf-cm, 21 ft-lbf)

NOTICE:
- Do not twist the wire harness for the front speed sensor when installing it.
- Tighten the brake flexible hose and front speed sensor together with the bolt. Make sure that the front speed sensor is positioned over the flexible hose.

(e) Install the No. 2 sensor clamp to the body with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)

(f) Connect the speed sensor wire harness clamp.
(g) Connect the speed sensor connector.
2. INSTALL FRONT FENDER LINER Installation
3. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. CHECK FOR SPEED SENSOR SIGNAL
HINT:
- w/o VSC Test Mode Procedure
- w/ VSC Test Mode Procedure