Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL

REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL Disassembly
3. REMOVE REAR DOOR ARMREST UPPER BASE PANEL Disassembly
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly
5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY Disassembly
6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP Disassembly
7. REMOVE REAR DOOR SERVICE HOLE COVER (w/o Power Door Lock) Disassembly
8. REMOVE REAR DOOR SERVICE HOLE COVER (w/ Power Door Lock) Disassembly
9. REMOVE REAR DOOR WEATHERSTRIP
10. REMOVE REAR DOOR GLASS RUN Disassembly
11. REMOVE REAR DOOR REAR WINDOW GUIDE SUB-ASSEMBLY Disassembly
12. REMOVE REAR DOOR REAR GUIDE SEAL Disassembly
13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly
14. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY Disassembly
15. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY





(a) Connect a positive (+) lead of the battery to terminal 1, and a negative (-) lead to terminal 2 of the rear power window regulator motor assembly to move the lift arm to the position shown in the illustration.





(b) Using a "TORX" driver (T25), remove the 3 screws and the rear power window regulator motor assembly.