Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.





(c) Using SST, install the center airbag sensor assembly with the 3 bolts.
SST: 09961-00950
without SST - Torque: 18 Nm (184 kgf-cm, 13 ft-lbf)
with SST - Torque: 11 Nm (112 kgf-cm, 8 ft-lbf)

NOTICE:
- Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
- This torque value is effective when SST is parallel to a torque wrench.
- If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- When the ignition switch is first turned to ON after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.





(d) Connect the holder (with connectors).
NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.

(e) Check that the waterproof sheet is properly set.
(f) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover) Installation
3. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Manual Transaxle) Installation
4. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Automatic Transaxle) Installation
5. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation
6. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation
7. INSTALL FRONT CONSOLE BOX ASSEMBLY (for 2WD) Installation
8. INSTALL FRONT CONSOLE BOX ASSEMBLY (for 4WD) Installation
9. INSTALL CONSOLE BOX CARPET
10. INSTALL NO. 2 SWITCH HOLE BASE Installation
11. INSTALL FRONT UPPER CONSOLE BOX Installation
12. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Manual Transaxle) Installation
13. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Automatic Transaxle) Installation
14. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Installation
15. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Installation
16. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
18. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.