Installation

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: INSTALLATION

INSTALLATION

1. INSTALL STEERING KNUCKLE





(a) Using SST and a press, install a new front axle hub bearing to the steering knuckle.
SST: 09950-60020
09951-00720
SST: 09950-70010
09951-07100
2. INSTALL FRONT DISC BRAKE DUST COVER Installation
3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY Installation
4. INSTALL FRONT AXLE HUB HOLE SNAP RING Installation
5. INSTALL FRONT LOWER BALL JOINT Installation
6. INSTALL FRONT AXLE ASSEMBLY Installation
7. CONNECT FRONT LOWER SUSPENSION ARM Installation
8. CONNECT TIE ROD END SUB-ASSEMBLY (for 2WD) Installation
9. CONNECT TIE ROD END SUB-ASSEMBLY (for 4WD) Installation
10. INSTALL FRONT DISC Installation
11. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Replacement
12. TEMPORARILY INSTALL FRONT AXLE SHAFT NUT Installation
13. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Replacement
14. REMOVE FRONT DISC Removal
15. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub
16. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub
17. INSTALL FRONT DISC Installation
18. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Replacement
19. INSTALL FRONT SPEED SENSOR Installation
20. INSTALL FRONT AXLE SHAFT NUT Installation
21. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
22. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT: Service and Repair

23. CHECK FOR SPEED SENSOR SIGNAL (w/ VSC)
HINT: Test Mode Procedure

24. CHECK FOR SPEED SENSOR SIGNAL (w/ ABS)
HINT: Test Mode Procedure