Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT PASSENGER AIRBAG ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL INSTRUMENT PANEL WIRE ASSEMBLY





(a) Install the clamp.





(b) Connect the 2 airbag connectors.
(c) Install the clamp and instrument panel wire assembly on the front passenger airbag assembly.
NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY





(a) Engage the 5 hooks.





(b) Install the front passenger airbag assembly with the 5 hooks on the upper instrument panel sub-assembly.





(c) Install the 2 screws.
3. INSTALL HEATER TO REGISTER DUCT ASSEMBLY Reassembly
4. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY Installation
5. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.





(c) Connect the connector.
NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.

6. INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
HINT: Refer to the procedure from Install No. 1 Instrument Panel Box Door Sub-assembly Installation.