Installation

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY





(a) Engage the adjuster positioning hole with the claw and install the front shoulder belt anchor adjuster assembly with the 2 bolts.
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)
2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY





(a) Install the front seat outer belt assembly with the 2 bolts.
Bolt [A] - Torque: 4.9 Nm (50 kgf-cm, 43 in-lbf)
Bolt [B] - Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)





(b) for Front Passenger Side:
(1) Engage the clamp.





(c) Connect the connector and lock the locking button as shown in the illustration.
NOTE: Securely lock the locking button.





(d) Connect the shoulder anchor of the front seat outer belt assembly with the nut.
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)
3. INSTALL UPPER CENTER PILLAR GARNISH Installation
4. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH (for Front Passenger Side)





(a) Install the floor end of the front seat outer belt assembly RH with the front seat belt anchor base.
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)
(b) Engage the clamp.
(c) Connect the connector.
(d) Check if the ELR locks.
NOTE: The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
5. INSTALL LOWER CENTER PILLAR GARNISH Installation
6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH (for Driver Side)





(a) Install the floor end of the front seat outer belt assembly LH with the bolt.
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)
(b) Check if the ELR locks.
NOTE: The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
7. INSTALL LAP BELT OUTER ANCHOR COVER (for Driver Side)





(a) Engage the 3 claws and install the lap belt outer anchor cover.
8. INSTALL LAP BELT OUTER ANCHOR COVER (for Front Passenger Side)





(a) Engage the 2 guides.





(b) Engage the 2 claws and install the lap belt outer anchor cover.
9. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP Installation
10. INSTALL REAR DOOR SCUFF PLATE Installation
11. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP Installation
12. INSTALL FRONT DOOR SCUFF PLATE Installation
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
14. INSPECT SRS WARNING LIGHT Diagnosis System