Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL SEAT POSITION SENSOR





(a) Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.





(b) Using a 1.3 mm (0.0512 in.) feeler gauge, set the seat position sensor.


NOTICE:
- If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
- When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
HINT: Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 to 2.0 mm (0.0236 to 0.0787 in.).





(c) Using a "TORX" socket wrench (T30), tighten the "TORX" screw to install the seat position sensor with the seat slide position sensor protector.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(d) Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 to 2.0 mm (0.0236 to 0.0787 in.).
(e) Connect the connector.
NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.

(f) Check that there is no looseness in the installation parts of the seat position sensor.
2. INSTALL FRONT SEAT CUSHION SHIELD (w/o Seatback Board) Reassembly
3. INSTALL VERTICAL ADJUSTING HANDLE (w/o Seatback Board) Reassembly
4. INSTALL VERTICAL SEAT ADJUSTER KNOB CAP (w/o Seatback Board) Reassembly
5. INSTALL RECLINING ADJUSTER RELEASE HANDLE (w/o Seatback Board) Reassembly
6. INSTALL FRONT SEAT CUSHION SHIELD RH (w/ Seatback Board) Reassembly
7. INSTALL RECLINING ADJUSTER RELEASE HANDLE RH (w/ Seatback Board) Reassembly
8. INSTALL FRONT SEAT ASSEMBLY (w/o Seatback Board) Installation
9. INSPECT FRONT SEAT SLIDE ADJUSTER LOCK (w/o Seatback Board) Installation
10. INSTALL INNER SEAT TRACK COVER (w/o Seatback Board) Installation
11. INSTALL OUTER SEAT TRACK COVER (w/o Seatback Board) Installation
12. INSTALL FRONT SEAT HEADREST ASSEMBLY (w/o Seatback Board)
13. INSTALL FRONT SEAT ASSEMBLY RH (w/ Seatback Board) Installation
14. INSPECT FRONT SEAT SLIDE ADJUSTER LOCK (w/ Seatback Board) Installation
15. INSTALL INNER SEAT TRACK COVER RH (w/ Seatback Board)
for 2WD: Installation
for 4WD: Installation
16. INSTALL OUTER SEAT TRACK COVER RH (w/ Seatback Board) Installation
17. INSTALL FRONT SEAT HEADREST ASSEMBLY (w/ Seatback Board)
18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
19. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.