Installation

E351 MANUAL TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE: INSTALLATION

INSTALLATION

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Install the transmission control cable assembly with the 2 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)





(b) Install the transmission control cable assembly with the nut.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)





(c) Install the 2 transmission control cables to the control cable bracket with 2 new clips*1.
(d) Install the 2 transmission control cables to the transaxle with the 2 clips*2.





(e) Rotate the transmission control cable nut counterclockwise approximately 180° and, while holding the nut in that position, press in the stopper until it makes 2 click sounds.





(f) Install the outer part of the transmission control cable to the shift lever retainer, check that the position of the spring is the same as A shown in the illustration, and push in the stopper.
HINT: If the stopper cannot be pushed in, slightly rotate the nut clockwise and then push in the stopper.





(g) Push the 2 claws together at the top of the transmission control cable lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to pull out the lock piece.





(h) Install the control shift cable to the shift lever assembly.
(i) Install the control select cable to the shift lever assembly.
NOTICE:
- Make sure that the lock piece is protruding from the adjuster case.
- Make sure to adjust the length at the neutral shift position.

(j) Press in and lock the lock piece to the adjuster case.
NOTE: Securely press in the lock piece until the lock engages.

2. ADJUST TRANSMISSION CONTROL SELECT CABLE Adjustments
3. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL Installation
4. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation
5. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Removal
6. INSTALL FRONT CONSOLE BOX ASSEMBLY Installation
7. INSTALL CONSOLE BOX CARPET
8. INSTALL NO. 2 SWITCH HOLE BASE Installation
9. INSTALL FRONT UPPER CONSOLE BOX Installation
10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Installation
11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation
12. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
13. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR





(a) Install the No. 1 front floor heat insulator with the 3 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
14. INSTALL CENTER EXHAUST PIPE ASSEMBLY Installation
15. INSTALL AIR CLEANER CASE Installation
16. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation
17. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation
18. INSPECT FOR EXHAUST GAS LEAK