Differential Case

E351 MANUAL TRANSMISSION / TRANSAXLE: DIFFERENTIAL CASE: INSPECTION

INSPECTION

1. INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER





(a) Using a micrometer, measure the thickness of the front differential pinion thrust washer.
Minimum thickness:
0.9 mm (0.0354 in.)
If the thickness is less than the minimum, replace the front differential pinion thrust washer.
2. INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT





(a) Using a micrometer, measure the outside diameter of the front No. 1 differential pinion shaft.
Minimum diameter:
17.975 mm (0.708 in.)
If the outer diameter is less than the minimum, replace the front No. 1 differential pinion shaft.