Removal

P112 HYBRID VEHICLE CONTROL: WATER PUMP WITH MOTOR: REMOVAL

REMOVAL

1. REMOVE REAR NO. 2 FLOOR BOARD Removal
2. REMOVE REAR DECK FLOOR BOX Removal
3. REMOVE REAR NO. 3 FLOOR BOARD Removal
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

5. DISCONNECT FRONT FENDER LINER LH Removal
6. DISCONNECT FRONT FENDER LINER RH Removal
7. REMOVE CENTER NO. 4 ENGINE UNDER COVER Removal
8. REMOVE FRONT SPOILER COVER Removal
9. REMOVE FRONT BUMPER COVER Removal
10. REMOVE FRONT BUMPER ENERGY ABSORBER
11. REMOVE HEADLIGHT ASSEMBLY LH
(a) Remove the headlight LH from the vehicle Removal.
12. DRAIN COOLANT (for Inverter) Coolant (for Inverter)
13. DISCONNECT WATER VALVE WITH BRACKET ASSEMBLY





(a) Remove the bolt and nut, then disconnect the water valve.
14. REMOVE WATER PUMP WITH MOTOR ASSEMBLY





(a) Disconnect the 2 inverter cooling hoses shown in the illustration.





(b) Remove the bolt, then disconnect the water pump with motor assembly from the vehicle.
(c) Disconnect the connector and remove the water pump with motor assembly.