Installation

1NZ-FXE COOLING: COOLANT HEAT STORAGE TANK: INSTALLATION

INSTALLATION

1. INSTALL COOLANT HEAT STORAGE TANK ASSEMBLY





(a) Insert the 2 claws shown in the illustration to the vehicle side, then insert the stud bolt to the vehicle side.
NOTE: The coolant storage tank bracket can be easily bent. Hold the coolant storage tank tightly when inserting the claws and stud bolt.





(b) Install the 4 bolts and nut.
Torque: 19 Nm (194 kgf-cm, 14 ft-lbf)

NOTICE:
- When tightening bolt 1 and 2, push the coolant heat storage tank bracket to the vehicle front.
- The coolant heat storage tank bracket can be easily bent. Hold the coolant heat storage tank tightly when installing the bolts and nut.





(c) Connect the water pump motor and temperature sensor connectors.





(d) Connect the 2 hoses shown in the illustration.
2. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL
3. INSTALL REAR NO. 3 FLOOR BOARD Installation
4. INSTALL REAR DECK FLOOR BOX Installation
5. INSTALL REAR NO. 2 FLOOR BOARD Installation
6. ADD ENGINE COOLANT (for Engine) Coolant (for Inverter)
7. INSPECT FOR COOLANT LEAK (for Engine)
8. INSTALL FRONT FENDER LINER LH
9. INSTALL FRONT BUMPER COVER Installation
10. INSTALL ENGINE UNDER COVER RH
11. INSTALL ENGINE UNDER COVER LH
12. INSTALL RADIATOR SUPPORT OPENING COVER Testing and Inspection
13. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.