Removal

P112 HYBRID VEHICLE CONTROL: HYBRID VEHICLE CONTROL ECU: REMOVAL

REMOVAL

1. REMOVE REAR NO. 2 FLOOR BOARD Removal
2. REMOVE REAR DECK FLOOR BOX Removal
3. REMOVE REAR NO. 3 FLOOR BOARD Removal
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

5. REMOVE NO. 1 INSTRUMENT PANEL REGISTER Removal
6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL Removal
7. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL Removal
8. REMOVE NO. 3 INSTRUMENT PANEL REGISTER Removal
9. REMOVE NO. 4 INSTRUMENT PANEL REGISTER Removal
10. REMOVE NO. 2 INSTRUMENT PANEL REGISTER Removal
11. REMOVE MULTI-DISPLAY ASSEMBLY Removal
12. REMOVE GLOVE COMPARTMENT DOOR STOPPER Removal
13. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal
14. REMOVE GLOVE COMPARTMENT DOOR Removal
15. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL
16. REMOVE FRONT PILLAR GARNISH CORNER PIECE RH
17. REMOVE FRONT PILLAR GARNISH CORNER PIECE LH
18. REMOVE FRONT PILLAR GARNISH RH
19. REMOVE FRONT PILLAR GARNISH LH
20. DISCONNECT AIRBAG CONNECTOR
21. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY Removal
22. REMOVE NO. 3 HEATER TO REGISTER DUCT Removal
23. REMOVE ECM Removal
24. REMOVE HYBRID VEHICLE CONTROL ECU





(a) Remove the 2 nuts and hybrid vehicle control ECU.