Installation

P112 HYBRID VEHICLE CONTROL: HYBRID VEHICLE CONTROL ECU: INSTALLATION

INSTALLATION

1. INSTALL HYBRID VEHICLE CONTROL ECU





(a) Install the hybrid vehicle control ECU with the 2 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
2. INSTALL ECM Installation
3. INSTALL NO. 3 HEATER TO REGISTER DUCT Installation
4. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY Installation
5. CONNECT AIRBAG CONNECTOR
6. INSTALL FRONT PILLAR GARNISH RH
7. INSTALL FRONT PILLAR GARNISH LH
8. INSTALL FRONT PILLAR GARNISH CORNER PIECE RH
9. INSTALL FRONT PILLAR GARNISH CORNER PIECE LH
10. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL
11. INSTALL GLOVE COMPARTMENT DOOR Installation
12. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation
13. INSTALL GLOVE COMPARTMENT DOOR STOPPER
14. INSTALL MULTI-DISPLAY ASSEMBLY
15. INSTALL NO. 2 INSTRUMENT PANEL REGISTER Installation
16. INSTALL NO. 4 INSTRUMENT PANEL REGISTER Installation
17. INSTALL NO. 3 INSTRUMENT PANEL REGISTER Installation
18. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL Installation
19. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation
20. INSTALL NO. 1 INSTRUMENT PANEL REGISTER Installation
21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation
22. CHECK SRS WARNING LIGHT
23. INSTALL REAR NO. 3 FLOOR BOARD Installation
24. INSTALL REAR DECK FLOOR BOX Installation
25. INSTALL REAR NO. 2 FLOOR BOARD Installation
26. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.