Installation

LIGHTING: REAR COMBINATION LIGHT ASSEMBLY: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH and LH sides.
- The procedures listed below are for the LH side.





1. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
(a) Install the 3 bulbs and bulb sockets to the rear combination light.
(b) Connect the connector and install the rear combination light.
(c) Slide the 2 pins towards the back of the vehicle to install them.
(d) Install the 2 nuts.
2. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.