Installation

TIRE AND WHEEL: TIRE PRESSURE WARNING ECU: INSTALLATION

INSTALLATION





1. INSTALL TIRE PRESSURE WARNING ECU
(a) Install the ECU with the bolt.
Torque: 7.5 Nm (76 kgf-cm, 66 in-lbf)
(b) Connect the connector.
2. INSTALL MULTI-DISPLAY ASSEMBLY
(a) Install the multi-display Installation.
3. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Installation
4. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY Installation
5. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Installation
6. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY UPPER Installation
7. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER Installation
8. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY Installation
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
- When the warning light is illuminated or the battery has been disconnected and reconnected, pressing the power switch may not start the system on the first try. If so, press the power switch again.
- With the power switch's power mode changed to ON (IG), disconnect the battery. If the key is not in the key slot during reconnection, DTC B2799 may be output.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. REGISTER TRANSMITTER ID
(a) Register the transmitter ID Registration.
11. INSPECT TIRE PRESSURE WARNING SYSTEM
(a) Inspect the tire pressure warning system Test Mode Procedure.