Removal

TIRE AND WHEEL: TIRE PRESSURE WARNING VALVE AND TRANSMITTER: REMOVAL

REMOVAL

1. REMOVE FRONT WHEEL
2. REMOVE REAR WHEEL
3. REMOVE TIRE PRESSURE WARNING VALVE SUB-ASSEMBLY
(a) Remove the valve core and cap, and release air from the tire.
(b) After ensuring that air is sufficiently released, remove the nut and washer that are used to fix the tire pressure warning valve and drop the valve sensor inside the tire.
HINT: Keep the removed cap, valve core, nut and washer.





(c) After dropping the tire pressure warning valve into the tire, disengage the bead using the shoe of the tire remover.
NOTE: Be careful not to damage the tire pressure warning valve because of interference between the sensor and tire bead.

(d) Remove the bead on the upper side.
(e) Take out the valve sensor from the tire and remove the bead on the lower bead.
HINT: Check that there are no cracks or damage on the grommet. If any damage is found, replace the grommet together with the washer and nut.