Installation

1NZ-FXE EMISSION CONTROL: FUEL TANK PRESSURE SENSOR: INSTALLATION

INSTALLATION

1. INSTALL FUEL TANK PRESSURE SENSOR





(a) Push the fuel tank pressure sensor to the plug of the fuel tank retainer, then install the tube joint clip.
- Check that there are no scratches or foreign objects around the connected part of the fuel tank pressure sensor and fuel tank retainer before this work.
- Check that the fuel tank pressure sensor is securely inserted to the end.
- Check that the tube joint clip is on the collar of the fuel tank pressure sensor.
- After installing the tube joint clip, check that the fuel tank pressure sensor cannot be pulled out.

(b) Connect the fuel tank pressure sensor connector.
2. INSTALL FUEL TANK SUB-ASSEMBLY Installation
3. INSTALL FRONT EXHAUST PIPE Installation
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation
5. INSPECT FOR FUEL LEAK Testing and Inspection
6. INSPECT FOR EXHAUST GAS LEAK Installation
7. INSTALL FRONT FLOOR PANEL BRACE Installation
8. INSTALL REAR FLOOR SERVICE HOLE COVER Installation
9. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
10. INSTALL LOWER CENTER INSTRUMENT PANEL FINNISH PANEL Installation
11. INSTALL REAR NO. 3 FLOOR BOARD Installation
12. INSTALL REAR DECK FLOOR BOX Installation
13. INSTALL REAR NO. 2 FLOOR BOARD Installation
14. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.