Installation

STEERING COLUMN: STEERING CONTROL ECU: INSTALLATION

INSTALLATION

1. INSTALL POWER STEERING ECU





(a) Install the ECU with the 3 screws.
Torque: 5.0 Nm (50 kgf-cm, 44 in-lbf)





(b) Connect the 4 ECU connectors.
(c) Install the torque sensor wire harness clamp to the ECU.
2. INSTALL INSTRUMENT PANEL SAFETY PAD Installation
3. INSTALL PASSENGER AIRBAG CONNECTOR Installation
4. INSTALL FRONT PILLAR GARNISH LH Installation
5. INSTALL FRONT PILLAR GARNISH RH Installation
6. INSTALL FRONT PILLAR GARNISH CORNER PIECE LH Installation
7. INSTALL FRONT PILLAR GARNISH CORNER PIECE RH Installation
8. INSTALL INSTRUMENT PANEL NO. 1 SPEAKER PANEL SUB-ASSEMBLY (w/ JBL Sound System)
9. INSTALL GLOVE COMPARTMENT DOOR Installation
10. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation
11. INSTALL GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY
12. INSTALL MULTI-DISPLAY ASSEMBLY Installation
13. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Installation
14. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY Installation
15. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Installation
16. INSTALL INSTRUMENT PANEL FINISH PANEL UPPER SUB-ASSEMBLY Installation
17. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER SUB-ASSEMBLY Installation
18. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY Installation
19. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

20. INSTALL NO. 3 REAR FLOOR BOARD
21. INSTALL REAR DECK FLOOR BOX
22. INSTALL NO. 2 REAR FLOOR BOARD
23. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.
24. PERFORM CALIBRATION
(a) Perform calibration Programming and Relearning.