Installation

AXLE: FRONT AXLE HUB BOLT: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. INSTALL FRONT AXLE HUB BOLT LH
(a) Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.





(b) Using a screwdriver or equivalent to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.
(c) Remove the 2 temporary nuts.
HINT: A plate washer of 5 mm (0.21 in.) or more in thickness is preferable.

2. INSTALL FRONT DISC
HINT: Align the matchmarks of the front disc and front axle hub before installing them.

3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH Installation
4. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)