Installation

AXLE: REAR AXLE HUB AND BEARING: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH
(a) Install the axle hub and bearing LH on the axle beam with the 4 bolts.
Torque: 61 Nm (622 kgf-cm, 45 ft-lbf)
2. CONNECT SKID CONTROL SENSOR CONNECTOR
3. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub and Bearing
4. INSPECT REAR AXLE HUB BEARING RUNOUT Rear Axle Hub and Bearing
5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
7. INSPECT REAR WHEEL ALIGNMENT Service and Repair
8. CHECK ABS SPEED SENSOR SIGNAL