Installation

EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION

INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY
(a) Connect the fog light connector. (w/ Fog Light)





(b) Engage the 4 claws to install the front bumper assembly.
HINT: Use the same procedure for the RH side and LH side.





(c) Install the clip.
(d) Install the 2 bolts and 6 screws.





(e) Install the screw.
HINT: Use the same procedure for the RH side and LH side.





(f) Install the pin hold clip.
NOTICE: Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.
HINT: Use the same procedure for the RH side and LH side.

2. INSTALL RADIATOR GRILLE Installation
3. INSTALL RADIATOR GRILLE PROTECTOR Installation
4. INSTALL COOL AIR INTAKE DUCT SEAL





(a) Install the cool air intake duct seal with the 12 clips.
5. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) Adjustments
6. PREPARE FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments
7. INSPECT FOG LIGHT AIMING (w/ Fog Light) Adjustments
8. ADJUST FOG LIGHT AIMING (w/ Fog Light) Adjustments