Installation

PARKING BRAKE: PARKING BRAKE SWITCH: INSTALLATION

INSTALLATION

1. INSTALL PARKING BRAKE SWITCH ASSEMBLY





(a) Install the parking brake switch assembly with the screw.
Torque: 0.9 Nm (9 kgf-cm, 8in-lbf)
2. INSTALL PARKING BRAKE PEDAL ASSEMBLY





(a) Install the parking brake pedal assembly with the 3 nuts.
Torque: 21 Nm (214 kgf-cm, 15ft-lbf)





(b) Connect the parking brake switch connector.
(c) Install the No. 1 parking brake cable assembly with the bolt and nut.





Nut - Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)
Bolt - Torque: 15 Nm (153 kgf-cm, 11ft-lbf)





(d) Connect the heated oxygen sensor connector and engage the 2 clamps (for 2GR-FE).
(e) Return the floor carpet assembly to an original state.
3. INSTALL CONSOLE BOX SUB-ASSEMBLY Installation
4. INSTALL POSITION INDICATOR HOUSING ASSEMBLY Installation
5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation
6. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
9. INSTALL FRONT DOOR SCUFF PLATE RH Installation
10. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation
11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
12. INSTALL FRONT DOOR SCUFF PLATE LH Installation
13. INSTALL AIR CONDITIONING CONTROL ASSEMBLY Installation
14. INSTALL CONSOLE BOX ASSEMBLY Installation
15. INSTALL NO. 2 CONSOLE BOX CARPET Installation
16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) Installation
17. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) Installation
18. INSTALL FRONT SEAT ASSEMBLY LH
HINT: Refer to the instructions for Installation of the front seat assembly.
- for Manual Seat: Installation
- for Power Seat: Installation

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

20. INSPECT BRAKE WARNING LIGHT Adjustments