Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: INSTALLATION

INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.

1. INSTALL REAR AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.





(c) Insert the pin (stopper) into the body hole and install the rear airbag sensor with the nut.
Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)

NOTICE:
- If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
- When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
- Make sure that the pin (stopper) is securely inserted into the body hole.
- Tighten the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

(d) Connect the connector to the rear airbag sensor assembly.
NOTICE: When connecting the airbag connector, take care not to damage the airbag wire harness.
(1) Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).





Text in Illustration





HINT: When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting, as it may result in an insecure fit.

(e) Check that there is no looseness in the installation parts of the rear airbag sensor.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY Installation
3. CONNECT REAR SEAT OUTER BELT ASSEMBLY Installation
4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP Installation
5. INSTALL REAR DOOR SCUFF PLATE Installation
6. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY Installation
7. INSTALL RECLINING REMOTE CONTROL BEZEL Installation
8. INSTALL REAR FLOOR FINISH PLATE Installation
9. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY Installation
10. INSTALL NO. 1 DECK BOARD Installation
11. INSTALL DECK SIDE TRIM BOX RH Installation
12. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY Installation
13. INSTALL DECK SIDE TRIM BOX LH Installation
14. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY Installation
15. INSTALL DECK BOARD ASSEMBLY Installation
16. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Installation
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

18. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check DTC Check / Clear.
19. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.