Replacement

MF1A TRANSFER / 4WD / AWD: TRANSFER CASE FRONT OIL SEAL (for RH Side): REPLACEMENT

REPLACEMENT

1. DRAIN TRANSFER OIL
(a) Remove the transfer drain plug and gasket to drain the transfer oil.
(b) Install a new gasket and the transfer drain plug.
Torque: 49 Nm (500 kgf-cm, 36ft-lbf)
2. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal.
3. REMOVE TRANSFER CASE FRONT OIL SEAL





(a) Using SST, remove the transfer case front oil seal from the transfer case.
SST: 09308-00010
NOTICE: Do not damage the oil seal contact surface on the case.

4. INSTALL TRANSFER CASE FRONT OIL SEAL





(a) Using SST, drive in a new transfer case front oil seal into the transfer case until it reaches the position shown in the illustration.
SST: 09950-60010
09951-00350
09951-00580
09952-06010
SST: 09950-70010
09951-07150
Drive in depth:
33.5 to 34.5 mm (1.319 to 1.358 in.)
NOTICE: Do not tilt the oil seal during installation.

(b) Apply a small amount of MP grease to the lip of the oil seal.
5. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH Installation.
6. ADD TRANSFER OIL
7. INSPECT TRANSFER OIL Testing and Inspection