Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for AWD): REMOVAL

REMOVAL
HINT:
- Use the same procedure for the LH side and RH side.
- The following procedure is for the LH side.
- If the sensor rotor needs to be replaced, replace it together with the rear drive shaft assembly.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR WHEEL
3. REMOVE REAR DOOR SCUFF PLATE LH Removal
4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH Removal
5. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Removal
6. REMOVE DECK BOARD ASSEMBLY Removal
7. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Removal
8. REMOVE DECK SIDE TRIM BOX LH Removal
9. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY Removal
10. REMOVE DECK SIDE TRIM BOX RH Removal
11. REMOVE NO. 1 DECK BOARD Removal
12. REMOVE REAR SEAT SUB FLOOR PANEL ASSEMBLY Removal
13. REMOVE REAR FLOOR FINISH PLATE Removal
14. REMOVE RECLINING REMOTE CONTROL BEZEL LH Removal
15. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY Removal
16. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH Removal
17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH Removal
18. REMOVE REAR SPEED SENSOR





(a) Disconnect the rear speed sensor connector.

Text in Illustration









(b) Disconnect the grommet of the rear speed sensor wire from the hole of the wheel house.

Text in Illustration





(c) Remove the 2 bolts, No. 1 clamp and No. 2 clamp from the body and absorber.





(d) Remove the bolt and rear speed sensor from the carrier.
NOTICE: Keep the sensor tip and rear speed sensor installation hole free from foreign matter.