Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR





(a) Install the yaw rate and acceleration sensor to the bracket with the 2 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)





(b) Install the yaw rate and acceleration sensor with bracket with the 2 bolts.
Torque: 13 Nm (127 kgf-cm, 9ft-lbf)

NOTICE:
- Be sure to insert the yaw rate and acceleration sensor claw into the stopper hole while installing the yaw rate and acceleration sensor.
- Do not damage the yaw rate and acceleration sensor.
- Make sure that the yaw rate and acceleration sensor is installed securely.

(c) Connect the connector to the yaw rate and acceleration sensor.
NOTICE: Make sure that the yaw rate and acceleration sensor connector is connected securely.

2. INSTALL NO. 4 CENTER MEMBER FLOOR REINFORCE SUB-ASSEMBLY





(a) Install the No. 4 center member floor reinforce sub-assembly with the 7 bolts.
Torque: 19 Nm (194 kgf-cm, 14ft-lbf)
(b) Return the floor carpet assembly to an original state.
3. INSTALL CONSOLE BOX SUB-ASSEMBLY Installation
4. INSTALL POSITION INDICATOR HOUSING ASSEMBLY Installation
5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation
6. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
9. INSTALL FRONT DOOR SCUFF PLATE RH Installation
10. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation
11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
12. INSTALL FRONT DOOR SCUFF PLATE LH Installation
13. INSTALL AIR CONDITIONING CONTROL ASSEMBLY Installation
14. INSTALL CONSOLE BOX ASSEMBLY Installation
15. INSTALL NO. 2 CONSOLE BOX CARPET Installation
16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) Installation
17. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) Installation
18. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat)
HINT: Refer to the instructions for Installation of the front seat assembly LH Installation.

19. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat)
HINT: Refer to the instructions for Installation of the front seat assembly LH Installation

20. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)
HINT: Perform the same procedure as the LH side.

21. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)
HINT: Perform the same procedure as the LH side.

22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

23. INSPECT SRS WARNING LIGHT
HINT: Description and Operation.