Installation

2GR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL ENGINE REAR OIL SEAL





(a) Apply MP grease to a new engine rear oil seal lip.
(b) Using SST and a hammer, tap in the engine rear oil seal.
SST: 09223-15030
SST: 09950-70010
09951-07150
Oil seal tap in depth:
-0.5 to 0.5 mm (-0.0196 to 0.0196 in.)
2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY





(a) Using SST, hold the crankshaft pulley.
SST: 09213-70011
09213-70020
SST: 09330-00021
(b) Clean the 8 bolts and 8 bolt holes.





(c) Install the front drive plate spacer.
HINT: Align the pin of the front drive spacer with the pin hole of the crankshaft.





(d) Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.





(e) Apply a few drops of adhesive to 2 or 3 threads of the 6 bolt tips.

Text in Illustration





Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent





(f) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
Torque: 83 Nm (846 kgf-cm, 61ft-lbf)
3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)
HINT: See the steps from "Install Automatic Transaxle Assembly" through "Install Engine Assembly with Transaxle" .

4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)
HINT: See the steps from "Install Automatic Transaxle Assembly" through "Install Engine Assembly with Transaxle" Installation.