Installation

2GR-FE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION

INSTALLATION

1. INSTALL NO. 2 OXYGEN SENSOR (for Bank 2 Sensor 2)





(a) Using SST, install the No. 2 oxygen sensor to the front exhaust pipe assembly.

Text in Illustration





SST: 09224-00010
without SST - Torque: 44 Nm (449 kgf-cm, 33ft-lbf)
with SST - Torque: 40 Nm (408 kgf-cm, 30ft-lbf)

NOTICE:
- The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
- The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
- The "with SST" torque value is effective when SST is parallel to the torque wrench.

2. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation
3. INSTALL OXYGEN SENSOR (for Bank 1 Sensor 2)





(a) Using SST, install the oxygen sensor to the center exhaust pipe assembly.

Text in Illustration





SST: 09224-00010
without SST - Torque: 44 Nm (449 kgf-cm, 33ft-lbf)
with SST - Torque: 40 Nm (408 kgf-cm, 30ft-lbf)

NOTICE:
- The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
- The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
- The "with SST" torque value is effective when SST is parallel to the torque wrench.

4. INSTALL NO. 3 FRONT EXHAUST PIPE SUB-ASSEMBLY Installation
5. INSPECT FOR EXHAUST GAS LEAK
6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
7. INSTALL FRONT DOOR SCUFF PLATE LH Installation
8. INSTALL NO. 1 ENGINE UNDER COVER
9. INSTALL NO. 2 ENGINE UNDER COVER