Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: REMOVAL

REMOVAL

1. PRECAUTION
CAUTION: Be sure to read Precaution thoroughly before servicing Service Precautions.

2. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE LOWER NO. 3 STEERING WHEEL COVER Removal
5. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal
6. REMOVE STEERING PAD Removal
7. REMOVE STEERING WHEEL ASSEMBLY Removal
8. REMOVE LOWER STEERING COLUMN COVER Removal
9. REMOVE UPPER STEERING COLUMN COVER Removal
10. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
NOTICE:
- Do not replace the spiral cable with the battery connected and the ignition switch on (IG).
- Do not rotate the spiral cable with the battery connected and the ignition switch on (IG).
- Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
- Do not remove the steering sensor from the spiral cable.

(a) Disconnect the connectors from the spiral cable with sensor sub-assembly.
NOTICE: When disconnecting any airbag connector, take care not to damage the airbag wire harness.





(b) Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.