Rear Door Panel: Service and Repair

DOOR / HATCH: REAR DOOR: DISASSEMBLY

DISASSEMBLY

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG





(a) Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel plug.
3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL





(a) Using a moulding remover, disengage the 2 clips and 5 claws.
(b) Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY





(a) Remove the 2 screws.
(b) Using a clip remover, disengage the 8 clips.
(c) Pull out the rear door trim board sub-assembly in the direction indicated by the arrow as shown in the illustration.
(d) Raise the rear door trim board sub-assembly and remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.





(e) Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.
(f) for 13 Speakers:
(1) Disconnect the connector.

To Install, reverse Removal procedure