Installation

1AR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL REAR ENGINE OIL SEAL
(a) Apply MP grease to the lip of a new oil seal.
NOTICE:
- Do not allow foreign matter to contact the lip of the oil seal.
- Do not allow MP grease to contact the dust seal.





(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.
SST: 09223-15030
SST: 09950-70010
09951-07150

NOTICE:
- Keep the lip of the oil seal free from foreign matter.
- Do not tap in the oil seal at an angle.

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY





(a) Using SST, hold the crankshaft.
SST: 09213-54015
SST: 91551-80650
SST: 09330-00021
(b) Clean the bolts and their installation holes.





(c) Install the front drive plate spacer.
HINT: Align the pin of the front drive plate spacer with the pin hole of the crankshaft.





(d) Install the drive plate and rear drive plate spacer to the crankshaft.





(e) Apply a few drops of adhesive to 2 or 3 threads of the bolt end.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent





(f) Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.
Torque: 98 Nm (999 kgf-cm, 72ft-lbf)
NOTICE: Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.

3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)
(a) Install the automatic transaxle Installation.
4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)
(a) Install the automatic transaxle .
5. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
(a) Install the engine and transaxle Installation.