Installation

1AR-FE FUEL: FUEL SENDER GAUGE ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL FUEL SENDER GAUGE ASSEMBLY





(a) Install the fuel sender gauge assembly to the fuel tank with the 6 bolts.
Torque: 3.5 Nm (36 kgf-cm, 31in-lbf)
NOTICE: Be careful not to bend the arm of the fuel sender gauge assembly.

2. INSTALL REAR NO. 2 FLOOR SERVICE HOLE COVER





(a) Connect the fuel sender gauge connector.
(b) Install the rear No. 2 floor service hole cover with new butyl tape.
3. INSTALL FUEL SENDER GAUGE





(a) Install the fuel sender gauge by sliding it downward.
NOTICE: Make sure that the fuel sender gauge arm does not bend.

(b) Connect the connector of the fuel sender gauge.
NOTICE: Do not damage the wire harness.

4. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
(a) Install the fuel suction tube assembly with pump and gauge Installation.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. INSPECT FOR FUEL LEAK Testing and Inspection