Installation

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION

INSTALLATION

1. INSTALL TIRE PRESSURE WARNING ANTENNA AND RECEIVER





(a) Connect the connector.





(b) Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning antenna and receiver.
(c) Install the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75in-lbf)
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
HINT:
- Refer to the procedures from "Install roof side inner garnish assembly" Installation.
- Installation should be performed only for the left side.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSPECT TIRE PRESSURE WARNING SYSTEM
(a) Inspect the tire pressure warning system Test Mode Procedure.