Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for 2WD): REMOVAL

REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
- The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
- If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR WHEEL
3. SEPARATE REAR SPEED SENSOR WIRE





(a) Using a screwdriver, disconnect the connector from the rear speed sensor.
NOTICE: Be careful not to damage the rear speed sensor.

4. SEPARATE REAR FLEXIBLE HOSE Removal
5. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Disassembly
6. REMOVE REAR DISC Removal
7. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
(a) Remove the rear axle hub and bearing assembly Removal.
HINT:
- The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
- If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.