Removal

2GR-FE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: REMOVAL

REMOVAL

1. REMOVE FRONT WHEEL RH
2. REMOVE NO. 1 ENGINE UNDER COVER
3. SEPARATE FRONT FENDER LINER RH
4. REMOVE FRONT FENDER APRON RH
5. REMOVE V-RIBBED BELT Removal
6. REMOVE CRANKSHAFT PULLEY





(a) Using SST, loosen the crankshaft pulley bolt.
SST: 09213-70011
09213-70020
SST: 09330-00021





(b) Using SST, remove the crankshaft pulley bolt and crankshaft pulley.
SST: 09950-50013
09951-05010
09952-05010
09953-05020
09954-05021





(c) Remove the pulley set key from the crankshaft.
7. REMOVE TIMING CHAIN CASE OIL SEAL





(a) Using a knife, cut off the timing chain case oil seal lip.
(b) Using a screwdriver, pry out the timing chain case oil seal.
NOTICE: After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.
HINT: Tape the screwdriver tip before use.