Technical Instructions For Venza

TECHNICAL INSTRUCTIONS

FOR

SAFETY RECALL C0E

STOP LAMP SWITCH & MOUNTING ADJUSTER REPLACEMENT

2009 THROUGH CERTAIN 2011 MODEL YEAR VENZA





I. OPERATION FLOW CHART

II. IDENTIFICATION OF AFFECTED VEHICLES





A. COVERED VIN RANGE





III. PREPARATION

IV. BACKGROUND

During assembly of the contact-type stop lamp switch into the vehicle, silicon grease may have come into contact with the surface of the switch. If the grease reaches the contact surface inside the switch, silica may be generated, and the contact resistance could increase. If this occurs, warning lamps could be illuminated, a no start condition could result, or the shift lever may not shift from the "Park" position. In some cases, the vehicle stop lamps could become inoperative. This could increase the risk of a crash.





V. STOP LAMP SWITCH & MOUNTING ADJUSTER REPLACEMENT

VI. APPENDIX





A. CAMPAIGN DESIGNATION DECODER

B. RECALL PARTS DISPOSAL

As required by Federal Regulations, please make sure all recalled parts (original parts) removed from the vehicle are disposed of in a manner in which they will not be reused, unless requested for parts recovery return.