Installation

AXLE AND DIFFERENTIAL: REAR AXLE HUB (for 2WD): INSTALLATION

INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY





(a) Install the parking brake assembly and the rear axle hub and bearing assembly with the 4 bolts.
Torque: 80 Nm (816 kgf-cm, 59ft-lbf)
NOTICE: Do not twist the No. 3 parking brake cable assembly when installing it.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub
3. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub
4. INSTALL REAR SPEED SENSOR WIRE Installation
5. INSTALL REAR DISC Installation
6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Reassembly
7. INSTALL REAR FLEXIBLE HOSE Installation
8. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76ft-lbf)
9. CHECK FOR SPEED SENSOR SIGNAL
(a) Check for the speed sensor signal Test Mode Procedure.