Installation

BRAKE CONTROL: FRONT SPEED SENSOR: INSTALLATION

INSTALLATION

1. INSTALL FRONT SPEED SENSOR





(a) Install the speed sensor onto the steering knuckle with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTICE:
- Check that the speed sensor tip and installation portion are free of foreign matter.
- Install the speed sensor without turning it from its original installation angle.

(b) Install the clamp onto the shock absorber with the bolt.
Torque: 29 Nm (300 kgf-cm, 22 ft-lbf)
(c) Install the clamp onto the body with the bolt.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
(d) Install the 3 clips.
(e) Connect the speed sensor connector.
(f) Install the speed sensor clip onto the body.
2. INSTALL FRONT FENDER LINER
(a) Install the front fender liner with the 3 screws, 6 clips and 4 grommets.
NOTE: The speed sensor wire should not protrude beyond the front fender liner.

3. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
5. CHECK ABS SENSOR SIGNAL
Test Mode Procedure