Installation

BRAKE CONTROL: SKID CONTROL SENSOR: INSTALLATION

INSTALLATION

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY Installation
2. INSPECT REAR AXLE HUB BEARING Component Tests and General Diagnostics
3. CONNECT SKID CONTROL SENSOR WIRE Installation
4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
5. ADJUST REAR DRUM BRAKE SHOE CLEARANCE Installation
6. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
8. CHECK ABS SENSOR SIGNAL
Test Mode Procedure