Installation

INSTRUMENT PANEL: UPPER INSTRUMENT PANEL (for Sedan): INSTALLATION

INSTALLATION





1. INSTALL NO. 3 INSTRUMENT PANEL CUSHION
(a) Install the instrument panel cushion onto the upper instrument panel.





2. INSTALL NO. 2 INSTRUMENT PANEL CUSHION
(a) Install the instrument panel cushion onto the upper instrument panel.





3. INSTALL NO. 1 INSTRUMENT PANEL CUSHION
(a) Install the instrument panel cushion onto the upper instrument panel.





4. INSTALL INSTRUMENT PANEL CUSHION
(a) Install the instrument panel cushion onto the upper instrument panel.
5. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY Installation





6. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
(a) Engage the 3 claws and install the register.
HINT: Use the same procedure for both sides.





7. INSTALL NO. 1 HEATER TO REGISTER DUCT
(a) Install the register duct with the 2 [A] screws.





8. INSTALL NO. 2 HEATER TO REGISTER DUCT
(a) Install the register duct with the 2 [A] screws.
9. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY





(a) Using a nipper, cut off both ends of the runner portion shown in the illustration (When installing a new one).
(b) Engage the 5 claws at the front side of the instrument panel.
(c) Engage the 7 clips at the rear side of the instrument panel.





(d) Install the upper instrument panel with the 2 [C] bolts and the 2 [B] screws.





Torque: 20 Nm (204 kgf-cm, 15 ft-lbf) for bolt [C]





(e) Connect the passenger airbag connector and clamp.
10. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY





(a) Engage the claws of the hinge portions by pushing the glove compartment door in the horizontal direction to install the glove compartment door assembly.
NOTE: Engage the claw by pushing it in the horizontal direction, otherwise, installation failure caused by excessive play around the hinge portion will result.





(b) Slightly flex the upper portion of the glove compartment door assembly to engage the stopper.
(c) Install the 2 glove compartment door stoppers onto the glove compartment door.
11. INSTALL FRONT PILLAR GARNISH RH Installation
12. INSTALL FRONT PILLAR GARNISH LH Installation
13. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
(a) Install the front door opening trim weatherstrip.
14. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
(a) Install the front door opening trim weatherstrip.
15. INSTALL COMBINATION METER ASSEMBLY Installation
16. INSTALL INSTRUMENT CLUSTER FINISH NO.1 PANEL Installation
17. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
18. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
19. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER Installation
20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
21. CHECK SRS WARNING LIGHT
Diagnosis System