Installation

LIGHTING: HAZARD WARNING SWITCH (for Sedan): INSTALLATION

INSTALLATION

1. INSTALL HAZARD WARNING SIGNAL SWITCH





(a) Engage the 3 claws and remove the hazard warning signal switch.
2. INSTALL INSTRUMENT PANEL CENTER REGISTER





(a) Engage the 8 claws and the instrument panel center register.
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY (w/o Radio Receiver) Installation
4. REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver) Installation
5. INSTALL INSTRUMENT CLUSTER FINISH NO.1 PANEL Installation
6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
7. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
8. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER Installation
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)