Removal

1NZ-FE EMISSION CONTROL: HEATED OXYGEN SENSOR: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER (for Sedan) Removal
3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for Sedan) Removal
4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
5. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Hatchback Manual Transaxle) Removal
6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) Removal
7. REMOVE CONSOLE BOX REAR COVER (for Hatchback) Removal
8. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Sedan) Removal
9. REMOVE CONSOLE BOX CARPET Removal
10. REMOVE REAR CONSOLE BOX ASSEMBLY Removal
11. REMOVE INSTRUMENT PAD LOWER LH (for Sedan) Installation
12. REMOVE HEATED OXYGEN SENSOR
(a) Disconnect the sensor connector.
(b) Remove the grommet and pass the sensor connector out of the cabin through the floor panel.