Installation

POWER STEERING: POWER STEERING ECU (for Hatchback): INSTALLATION

INSTALLATION

1. INSTALL POWER STEERING ECU





(a) Install the power steering ECU with the 2 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)





(b) Connect the 4 connectors.





(c) Install the wire harness clamp.
NOTE: Make sure that the wire harness of the steering column assembly is installed onto the power steering ECU bracket and that it is not pulled too tightly.

2. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY Installation
3. INSTALL NO. 1 SWITCH HOLE BASE Installation
4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation
5. INSTALL FRONT PILLAR GARNISH RH Installation
6. INSTALL FRONT PILLAR GARNISH LH Installation
7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation
8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
HINT: Use the same procedure for the RH side as for the LH side.

9. INSTALL COMBINATION METER ASSEMBLY Installation
10. INSTALL INSTRUMENT CLUSTER FINISH NO.1 PANEL Installation
11. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
12. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
14. PERFORM CALIBRATION OF TORQUE SENSOR ZERO POINT
Programming and Relearning.