Installation

U340E AUTOMATIC TRANSAXLE: TRANSMISSION CONTROL CABLE ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Install the control cable onto the control shaft lever with the nut.
Torque: 12 Nm (122 kgf-cm, 9 ft-lbf)
(b) Fix the control cable onto the control cable bracket with a new clip.

(d) Install the control cable with the 3 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)

(e) Turn the nut of the control cable and push in the lock.

(f) Install the control cable onto the shift lever retainer.
NOTICE:
- Install the cable with the protruding portion of the cable outer facing upward.
- After installing, check that the lock of the cable outer is protruding beyond portion A-A, as shown in the illustration.

(g) Connect the control cable to the shift lever.
NOTE: Connect the control cable so that the adjusting mechanism lock of the control cable is installed on the left side of the vehicle.

2. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
(a) Install floor heat insulator with the 2 bolts and the nut.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
3. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

4. CONNECT OXYGEN SENSOR CONNECTOR
(a) Insert the oxygen sensor connector toward the room side, through the hole in the floor panel, and then install the grommet.
(b) Connect the oxygen sensor connector.
5. INSTALL AIR CLEANER BRACKET Installation
6. INSTALL AIR CLEANER ASSEMBLY Installation
7. INSTALL BATTERY TRAY
8. INSTALL BATTERY Installation
9. INSPECT SHIFT LEVER POSITION U340E Automatic Transaxle
10. ADJUST SHIFT LEVER POSITION Adjustments
11. INSTALL REAR CONSOLE BOX ASSEMBLY Installation
12. INSTALL CONSOLE BOX CARPET Installation
13. INSTALL REAR CONSOLE BOX COVER (for Hatchback) Installation
14. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) Installation
15. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) Installation
16. INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL (for Sedan) Installation
17. CHECK FOR EXHAUST GAS LEAKAGE