Installation

AXLE: REAR AXLE HUB AND BEARING: INSTALLATION

INSTALLATION





1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
(a) Install the axle hub and bearing onto the axle beam with the 4 bolts.
Torque: 90 Nm (918 kgf-cm, 67 ft-lbf)
2. INSPECT REAR AXLE HUB BEARING Component Tests and General Diagnostics





3. CONNECT SKID CONTROL SENSOR WIRE (w/ ABS)
(a) Connect the skid control sensor wire connector.
4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
5. ADJUST REAR DRUM BRAKE SHOE CLEARANCE Installation
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
8. CHECK ABS SENSOR SIGNAL (w/ ABS)
Test Mode Procedure